Hello Guest it is April 18, 2024, 09:23:46 PM
Profile Guest

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - mt-wrg

Pages: 1
1
Newfangled Solutions Mach3 Wizards / Re: PowerFeed XY
« on: February 26, 2013, 05:00:35 PM »
I actually meant two buttons for each axis, one to add the dro, the other subtracts the dro.

2
Newfangled Solutions Mach3 Wizards / PowerFeed XY
« on: February 25, 2013, 10:08:38 PM »
I think it would be nice to be able to step x , y, z   positive or negative so you could back tool out to rapid back.  For instance if you are milling on the side of stock.

Pages: 1