Hello Guest it is March 28, 2024, 09:18:03 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - rrc1962

111
Mach4 General Discussion / Re: MACH4 - Modbus
« on: May 17, 2015, 08:10:36 PM »
Cool.  That's good news.

112
Mach4 General Discussion / Re: MACH4 - Modbus
« on: May 17, 2015, 05:47:51 PM »
Is Ethernet Modbus working in M4?  I went through a few pages of posts and it seems everyone is working with serial Modbus.  The device I'm connecting to requires Modbus TCP.

Thanks

113
Mach4 General Discussion / G31 and ESS
« on: May 16, 2015, 09:12:09 PM »
Can someone running an ESS confirm whether G31 works or not?

Thanks

114
Mach4 General Discussion / Re: Zero All
« on: May 16, 2015, 02:20:19 PM »
Thanks guys....Seems like everything has to be "coded" in M4.

115
Mach4 General Discussion / Zero All
« on: May 16, 2015, 12:51:13 PM »
I see button actions to zero the individual axes, but not a "Zero All".  Is there a way to zero all?  Maybe an equivalent to doOemButton() wher you can call the ZeroX, ZeroY and ZeroZ actions?

Thanks

116
Mach4 General Discussion / Re: Persistent DRO's
« on: May 16, 2015, 12:20:01 PM »
I was hoping for a check box somewhere called "Persisent DRO's"...like in M3.  No big deal to code it though.

117
Mach4 General Discussion / Persistent DRO's
« on: May 15, 2015, 10:31:36 PM »
Is there a way...or a setting...to make DRO's persistent like in M3?  Or do I have to save them in registers on exit and load on startup?  If that's the case, where would that script go?

Thanks

118
Mach4 General Discussion / Re: Add a tab to a tab panel
« on: May 15, 2015, 09:32:38 PM »
Figured it out.  Just hit the add page button.  I was thinking that would add another entire screen.

119
Mach4 General Discussion / Add a tab to a tab panel
« on: May 15, 2015, 09:27:15 PM »
I'd like to add a tab to the Operations Tab that already exists in M4.  How is that done? 

Thanks

120
Mach4 General Discussion / Re: Mach4/ESS sort of working
« on: May 15, 2015, 04:20:52 PM »
Enable is on and Enable 0,1 and 2 are lit. 
I have only ever had this happen once and it was to do with the estop on pin 10, it also showed a red light on the ess.

DazTheGas

That was it.  Thanks for the tip.  Even though the estop in Mach3 was sowing disabled, the ESS was in estop.  Reversing the pin state in the ESS plugin did the trick.