141
General Mach Discussion / Re: UC100 - Problems getting Mach 3 to talk to the mill
« on: September 28, 2013, 11:26:21 PM »
Did you download and install the driver for the UC-100? It will configure the ports. After the driver is installed, you should get a message when you start M3 to allow you to select the PPort or the UC-100.
I'm typing this from memory as my UC-100 is 120 miles form my present location. The driver can be downloaded here: http://cncdrive.com/UC100.html
John Champlain
I'm typing this from memory as my UC-100 is 120 miles form my present location. The driver can be downloaded here: http://cncdrive.com/UC100.html
John Champlain