1
General Mach Discussion / Mach3 Loads files when e-stopped but not when in normal mode
« on: August 22, 2008, 02:12:24 PM »
Hello,
I've been fussing with Mach3 the last couple days, the problem i'm having is that when I first load mach3 up and I load any gcode file it will load great even the samples that come with the program. If I press the e-stop to bring the system to normal mode and try to load a gcode file I will get only like 1/4 of the program. If I exit mach and return and try again it will load the files fine untill you press e-stop then it will start doing it again.
Any ideas?
I'm runing Windows XP
256MB graphics card
1gb ram
I've been fussing with Mach3 the last couple days, the problem i'm having is that when I first load mach3 up and I load any gcode file it will load great even the samples that come with the program. If I press the e-stop to bring the system to normal mode and try to load a gcode file I will get only like 1/4 of the program. If I exit mach and return and try again it will load the files fine untill you press e-stop then it will start doing it again.
Any ideas?
I'm runing Windows XP
256MB graphics card
1gb ram