Messages

11

General Mach Discussion / Re: Cutting speed

« on: April 30, 2010, 03:00:24 PM »

Hi all my friend
Thank you for your answer but my basic question was for how calculate the maximum rapid travels and feed rate for any servo motor ?
Why some cnc machine say the rapid travels is 24m/min and feed rate is 1-8 m/min and in some machine say rapid travels is 24m/min and 1-10 m/min feed rate.
What is formulas is use for difference between rapid travels and feed rate?
Thank you

12

General Mach Discussion / Cutting speed

« on: April 30, 2010, 07:56:37 AM »

Hi
Can anyone tell me:
How calculate the cutting speed and rapid travels for cnc machines?
for example many milling machine have 24m/min speed for rapid travels and 1-10m/min for cutting speed.
Can i also use more than of 10m/min for cutting speed or not? Why?
Thank you
SML

13

General Mach Discussion / Mach3 by Linux

« on: April 12, 2010, 01:34:09 PM »

Hi
Can i setup  and run mach3 on Linux ?
Does mach3 have any version for Linus?
Thank you

14

General Mach Discussion / Re: Ballbar test

« on: April 12, 2010, 11:41:44 AM »

Thank you Hood
So why other cnc machine need ballbar test? Does it haven't motor tuning?

15

General Mach Discussion / Ballbar test

« on: April 12, 2010, 10:04:58 AM »

Hi
Does i need ballbar test for my cnc milling machine? or motor tuning is enough ?
Does i need ballbar test for using motor tuning?
Please tell me more
Thank you.

16

General Mach Discussion / Re: RS232

« on: April 08, 2010, 11:06:14 AM »

Ok
Thank you

17

General Mach Discussion / RS232

« on: April 08, 2010, 10:47:23 AM »

Hi
Can i transfer a DXF file by RS232 cable from computer to another computer that has mach3 software ?
Thank you

18

General Mach Discussion / Re: screen button

« on: March 25, 2010, 03:26:51 AM »

yes

19

General Mach Discussion / screen button

« on: March 24, 2010, 01:37:13 PM »

Hi
Please help me for screen button.
I design a new screen.set but i have a problem with jog button.In one page of screen the keyboard jog button ( page up and down for z axes) is working but in other page these keyboard button don't work.
What is the problem?

Thank you
  

20

General Mach Discussion / Re: program

« on: February 20, 2010, 04:47:49 AM »

What program is used for create(write) Mach3 ?