Hello Guest it is April 25, 2024, 03:24:36 AM
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
| Filename | Downloads | Message |
Posted
|
|---|---|---|---|
| panel102809.jpg | 653 | 1979 Takisawa DTX-1 Turret Lathe | October 29, 2009, 01:00:15 AM |
| P1010002-102809.JPG | 666 | 1979 Takisawa DTX-1 Turret Lathe | October 29, 2009, 01:00:15 AM |
| turret102809.jpg | 634 | 1979 Takisawa DTX-1 Turret Lathe | October 29, 2009, 01:00:15 AM |
| P1010032-102809.JPG | 629 | 1979 Takisawa DTX-1 Turret Lathe | October 29, 2009, 01:00:15 AM |
| M6Start112109.m1s | 391 | Re: Lathe turret, VB, PLC, MODBUS, Position | November 21, 2009, 02:17:35 PM |
| takisawa-panel1.jpg | 587 | 1979 Takisawa DTX-1 Turret Lathe Update | November 24, 2009, 04:10:40 PM |
| takisawa-drive1.jpg | 551 | 1979 Takisawa DTX-1 Turret Lathe Update | November 24, 2009, 04:10:40 PM |
| takisawa-front1.jpg | 527 | 1979 Takisawa DTX-1 Turret Lathe Update | November 24, 2009, 04:10:40 PM |
| takisawa-spindle1.jpg | 619 | 1979 Takisawa DTX-1 Turret Lathe Update | November 24, 2009, 04:10:40 PM |
| sprutcam_turn_post_mach3.txt | 523 | Lathe G1 XYZ move servos ""jump" to position | January 03, 2010, 02:32:27 PM |
Guest