11
General Mach Discussion / Re: incorrect dimensions when inverting x axis
« on: September 14, 2010, 05:09:57 PM »
there is/was no reason to disable enhanced pulsing..
No the circles are real circles no ovals
we tried your G51X-1 method but this is not a good way because we intend to reverse the board and align it to the other symetric side of the machine because we have only one boardside that is referenced
No the circles are real circles no ovals
we tried your G51X-1 method but this is not a good way because we intend to reverse the board and align it to the other symetric side of the machine because we have only one boardside that is referenced