Hello Guest it is March 28, 2023, 02:48:10 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - kramerda

Pages: 1
General Mach Discussion / Re: More text and engrave questions
« on: October 27, 2009, 02:39:58 PM »
Thanks for the idea - do you know if the driver will run on a Win XP machine - is available anywhere?

General Mach Discussion / More text and engrave questions
« on: October 26, 2009, 04:33:26 PM »
Tried to do lots of searhing before rekindling,  this topic but never found an answer so here goes

Is there a simpleway to get multiple lines of text engraved?
LazyCam only does one at a time, same for DeskEngrave.

Thought I could convert text using HPGL driver but no luck in finding a way to do that.
Thought about using an HP driver for old 7475a plotter (HP says no longer available)

I'm not into VB and don't have access to AutoCAD.......

Any thoughts appreciated.  Text to DXF or Text to HPGL ???


Pages: 1