Hello Guest it is December 02, 2021, 02:57:25 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Captain Midnight

Pages: « 1 2 3 4 5 6 7 8 9 »
11
General Mach Discussion / Re: On the fly z axis adjustment?
« on: August 22, 2012, 07:42:13 PM »
Jogging is disabled while a program is running.
Maybe a spring loaded tool holder would allow for more even depth?

12
No, ethernet.

13
General Mach Discussion / Re: Joypad Plugin
« on: July 21, 2012, 04:26:00 PM »
Oh, I think I found it. I posted over there first, but nobody's talking.

14
General Mach Discussion / Re: Joypad Plugin
« on: July 21, 2012, 04:21:56 PM »
Thank you, I will do that. How do I find the "plug-ins forum"?

15
Yes, I did that. All the buttons and joysticks are recognized under setup. All buttons work, just not joysticks.
Thank you

16
General Mach Discussion / Re: Joypad Plugin
« on: July 21, 2012, 02:16:10 AM »
I purchased a Joypad and set it up. It does'nt work either. Please help me. I really want this to work.
Thanks

17
I received my new Joypad and it won't contiuosly jog either. Any ideas why it won't jog? It is setup as manual says. I have read all the posts. I have reviewed the manual.
Thanks for help

18
I have plugin installed, and buttons work, sticks are calibrated. I can get step jogging, but no amount of effort can get continuous jogging to work. What should I look at, or test, or try? I really want to make this work.
Thanks

19
Yes, I'm good there. I purchased a Joypad off e-bay, when it gets here, I'll see if it works differently than the Lodgitech Attack 3.
Thank you for working with me. I'm hopefull I can get a joystick to work.

20
While in continuous mode, if I push SL and move joystick, it changes back to step mode by itself. It will not stay in continuous mode. Jogging with keypad works normally.

Pages: « 1 2 3 4 5 6 7 8 9 »