Hello Guest it is December 02, 2021, 03:01:07 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Captain Midnight

Pages: 1 2 3 4 5 6 7 8 9
1
Yes, that may be the problem.

2
Yes. Here is the problem.

3
The file transfers from the thumb drive OK, but when I open it , it is not readable. It looks like Chinese.

4
I am so confused. How would you load a program from a home computer to the shop computer? I'll try to follow instructions.

5
My indoor computer runs Windows 7. I used Via-Cad 6 to draw my part and save as a DXF R-12 file. I open the same DXF file in LazyCam and edit it. I then post it to Mach 3. It opens in Mach 3 fine. I test run in Mach 3. It works fine. Now how do I get this g-code program from my indoor computer, that is running Windows 7, to my shop computer that is running XP?  I tried using a thumb drive to transfer the program, but the shop computer doesn't recognize it. I know I need to save or convert it to some common format. Would some show me how to do that?
Thank you very much, I am a little computer slow, and I need some computer love here.

6
General Mach Discussion / Re: New type Mach3 conversational PAGE
« on: March 25, 2013, 08:14:49 PM »
Thank you so much.

7
General Mach Discussion / Re: New type Mach3 conversational PAGE
« on: March 25, 2013, 01:08:47 PM »
Maybe added to the wizards in my screen set?

8
General Mach Discussion / Re: New type Mach3 conversational PAGE
« on: March 25, 2013, 12:58:40 AM »
How is this downloaded for use? It looks like something I could use.
Thanks

9
Share Your GCode / G code for edge radius
« on: November 21, 2012, 06:06:49 PM »
What is the proper way to cut a radius over an edge to make a .750" chamfer?  Do I need to program this in the z-y plane?

10
I have an Ajax controller also. I'm trying to use joypad. All the buttons and everything work, except  jogging. Let me know how this progresses.

Pages: 1 2 3 4 5 6 7 8 9