Guest
Show Posts
1
General Mach Discussion / Z works fine but problem with X Y A 4Axis controler
« on: July 24, 2010, 06:14:57 PM »
Hey,
I hope there is someone here who can help me solve a problem with my Mach3. I bought initially one controler and it all went right after the book, I was so unlucky that a wire to one of steppermotor hung in a screw, thereby causing a short circuit.
I have now bought a new 4 axis Controler: TA8435H and it looks good, I got the Z axis to be working fine, but XYA does not work, they only get power when I press estop, ( the flashes of Mach3 ). I've messed around with port and pins but could´n see what I have done wrong, hope you can give me a hint.
Thanks.
Regards
Jens Jorgen Hansen
Denmark.
I hope there is someone here who can help me solve a problem with my Mach3. I bought initially one controler and it all went right after the book, I was so unlucky that a wire to one of steppermotor hung in a screw, thereby causing a short circuit.
I have now bought a new 4 axis Controler: TA8435H and it looks good, I got the Z axis to be working fine, but XYA does not work, they only get power when I press estop, ( the flashes of Mach3 ). I've messed around with port and pins but could´n see what I have done wrong, hope you can give me a hint.
Thanks.
Regards
Jens Jorgen Hansen
Denmark.