Messages

81

General Mach Discussion / pulse indexing help needed

« on: January 24, 2012, 10:19:24 PM »

optical switch works fine to the bob but machturn does not seem to use the info well.
i have an xlm if some one can look it over?
the bob red light shows good accuracy but mach seems to skip some pulses and does nothing but read 260rpm. lol

82

General Mach Discussion / Re: cant open up the mach turn users guide pdf

« on: January 19, 2012, 04:07:28 PM »

wow, that works perfect
thanks!

83

General Mach Discussion / Re: cant open up the mach turn users guide pdf

« on: January 19, 2012, 02:41:18 PM »

what is foxit?

84

General Mach Discussion / cant open up the mach turn users guide pdf

« on: January 19, 2012, 01:58:21 PM »

i have tryed on all 3 of my computers and it locks up every time.
is there a file i can open or some other way than the pdf?
thanks matt

85

General Mach Discussion / Re: changed the kernal to 100 and cant open machturn now

« on: January 18, 2012, 01:34:10 PM »

thanks!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

86

General Mach Discussion / changed the kernal to 100 and cant open machturn now

« on: January 18, 2012, 12:16:51 PM »

is there a way to get into the xml file or something to turn down the kernal speed?
i set it at 100 trying out some different speeds and now she just locks up the computer when i open up the machturn. ???lol
this is a weaker xp running puter
1.1 mhz and 1gig ram
thanks matt

87

SmoothStepper USB / Re: "time out error getting data" wtf

« on: August 30, 2011, 02:07:00 PM »

well, it did it again so i hooked up the external 5v and will see what happens next. works for now...........

88

SmoothStepper USB / Re: "time out error getting data" wtf

« on: August 19, 2011, 06:04:33 PM »

ha, so blinking red is good? i swear it has not blinked red yet while running and i have been cutting for a descent amount of time.

89

SmoothStepper USB / Re: "time out error getting data" wtf

« on: August 19, 2011, 05:20:12 PM »

well, after just leaving it off for lunch it now works again but has the red light blinky fast.
is there a code book for this?

90

SmoothStepper USB / Re: "time out error getting data" wtf

« on: August 19, 2011, 04:00:46 PM »

the ss is holding on the flood and chip auger relays too. even with it unplugged from the pc.