Hello Guest it is March 28, 2024, 05:52:40 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - turbothis

Pages: « 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 »
31
hhmmmmm....
i guess i will see if i can find some info on these as i do not have a manual.

32
how do i look for a transformer to get me down in voltage?
this is new tech to me. i can do geckos but thats about it....

33
so rectify and see what i get? how do i smooth it out?
thanks as always!

34
in the drivers?
this is all i got other than a couple little transformers and what look like small breakers or relays.
http://www.ebay.com/itm/170808712652?ssPageName=STRK:MESELX:IT&_trksid=p3984.m1555.l2649

35
looks like bds4206 23412w32
thanks on the dc!

36
what kind of power supply can i use? i am out of my garage and have only good amp 220 service.

37
if i cant use the motors i will just sell them off too.
i was thinking maybe the biggest keling servos would be enough. not looking for speed on this mill, just rigid,accurate and toolchanger.
it has no spindle motor and i think i might be about to get a 5-10hp on there later.

38
General Mach Discussion / mach conversion to a cincinnati sabre 750
« on: March 20, 2012, 04:15:31 PM »
i just got a sabre 750 and are planning on going the mach route on it. it came with the acramatic 850sx controller but i am selling it all off to pay for the iron.
1 are the brushless (i assume ac) motors on the mill now going to be costly to make step/direction run?
specs are z axis


and i assume both x and y are


this came with some bds4's that i think are the drives?

39
General Mach Discussion / Re: help with step/direction vfd lathe spindle
« on: February 25, 2012, 11:00:02 AM »
yes while running
my mill say 10v while running full speed.
this thing is very strange.
i dont mind what it does/says as long as it makes parts. lol

40
General Mach Discussion / Re: help with step/direction vfd lathe spindle
« on: February 24, 2012, 11:06:55 AM »
ya, i thought the meter was reading funny too.
it reads 13v on the input and 1.56v on the output at 100% speed.
how does the vfd work with this i have no idea.

Pages: « 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 »