Hello Guest it is March 28, 2024, 05:15:16 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - madmacs

Pages: 1
1
FAQs / Voltage swing
« on: October 05, 2009, 06:51:33 AM »
I am having  a problem with getting my stepper kit run. I think I have found the problem. When using the jog button i find the pin that is switching but the swing is from 3Mv to 23Mv when the x jog button is pressed. Do I need a different board before the BOB to pump up signal
Thanks
jim

2
FAQs / Need help mach 3
« on: October 03, 2009, 12:25:08 PM »
I have mach 3 running on windows xp and i cannot communicate to my driver board. the driver board is intergration solutions c10 Bi directional parallel port. I have gone thru the pin outs and they seem to correct but when jog with jog buttons the motors do run, the dro on the monitor is showing movement but no movement with motors. Im assuming this is any fix that im missing any help would great.
Jim

Pages: 1