Hello Guest it is September 19, 2020, 06:55:11 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - macavity

Pages: 1
1
General Mach Discussion / Different speeds on lines and arcs
« on: October 01, 2009, 05:22:45 AM »
Hi,
i have a problem. Mach does not maintain constant speed (feedrate)  when executing my gcode. Differences are rather significant, ranging from 1800 to 1400 mm/min (you may imagine the jerking). and appear when i cut corners using g02/g03. my machine is plotter for cutting glass (thus high speed) but i observe this on 3 different pc, including C2Quad 2,4Ghz.
Has any of you came across similar phenomenon?

Pages: 1