1
General Mach Discussion / VB macro & shuttle.
« on: September 30, 2009, 03:55:22 AM »
Hello everyone
I am moving the lathe in using MACH3.
This is a question of the VBmacro & shuttle.
I want to make the chamfering of the lathe in using the jog dial of the shuttle.
How can I move the tool by VBMacro ,for direction 45degrees by synchronizing with the jog dial?
I am moving the lathe in using MACH3.
This is a question of the VBmacro & shuttle.
I want to make the chamfering of the lathe in using the jog dial of the shuttle.
How can I move the tool by VBMacro ,for direction 45degrees by synchronizing with the jog dial?