Hello Guest it is March 28, 2024, 05:27:02 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Pico

Pages: « 1 2 3 4 »
21
General Mach Discussion / Re: Cuts much too large
« on: March 03, 2011, 04:21:11 PM »
Don't know. I set this thing up over two years ago and don't remember what I set it at. I think I lost some settings in a computer problem and I've been having  difficulties ever since. What do you suggest? I'll run down and try 10,000 to see if it works better. I tried the automatic set several days ago and that cranked it up waaaay too much.

22
General Mach Discussion / Re: Cuts much too large
« on: March 03, 2011, 03:14:32 PM »
Here it is.

23
General Mach Discussion / Re: Cuts much too large
« on: March 03, 2011, 11:49:23 AM »
Does it have a different name than config? I went through properties - target and ended at the same place as before. No config folder there. Thanks.

24
General Mach Discussion / Re: Cuts much too large
« on: March 03, 2011, 09:46:38 AM »
The native units is in English Gcode, as is my gcode. So that is correct. I have attempted to find the config file. I  went to: my computer - local disc (C) - Mach3 and there is no config file. I also went to program files and there is no Mach3 there. Where do I go to now? Thanks for the help.

25
General Mach Discussion / Re: Cuts much too large
« on: March 02, 2011, 05:01:00 PM »
I do type in G0 X10 but when I click enter, it cancels. What is xml? Thanks.

26
General Mach Discussion / Re: Cuts much too large
« on: March 02, 2011, 03:48:07 PM »
This does not happen with jogging. It happens with code - and is driving me further crazy as I was just fiddling with it and it is now cutting  small, maybe 1/10th the size it's suppose to. I can't use the MDI command as a small blank box tops up above the "Input" and I type a command in and hit "Input" and the command cancels. The scale set by the DROs says +1.00. Thanks for your help.

27
General Mach Discussion / Cuts much too large
« on: February 27, 2011, 11:28:44 AM »
I'm probably making a really stupid basic mistake, but I've been playing around with this thing for the last two days and can't understand what's wrong. My router (rockcliff with cnchobby controller) makes cuts about 5 to 6 times larger than it should. I have checked the motor tuning settings which have not changed so that doesn't appear to be the problem. Help!

28
General Mach Discussion / Re: Z axis cutting too deep
« on: December 19, 2009, 05:46:13 PM »
Thanks for the advice, will try when I get back.      Pico

29
General Mach Discussion / Re: Z axis cutting too deep
« on: December 19, 2009, 05:25:58 PM »
Tried that, doesn't change anything. I'll be gone for a week and will return on the 28th to continue experimenting with a solution. Thanks,     Pico

30
General Mach Discussion / Re: Z axis cutting too deep
« on: December 18, 2009, 06:03:38 PM »
Will do, Thanks.     Pico

Pages: « 1 2 3 4 »