Messages

61

Mach3 and G-Rex / Re: how to config motors with G100

« on: May 10, 2010, 01:33:00 PM »

Ok, Here is a question for you!  My DIY CNC Quilter is working just fine, however, (there is always a however these days) when I measure the travel in X and Y axis after inputing a requirement to travel 1 inch, I get travel of 13 inches.  I don't want to reduce the speed of the motors (steps), I would like to insert a formula that will reset the values of 1 inch = 0.0680.  I arrived at 0.0680 after adjusting the speed of the motors to a comfortable level that doesn't skip.  If this is possible, where is it located in the Mach3 program? In a dll or someplace else?  Sure hope you can help on this.