Hello Guest it is August 10, 2022, 12:52:30 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - fetchy

Pages: 1
1
General Mach Discussion / Re: need help with input signals!
« on: August 25, 2009, 09:32:18 AM »
thank you filipe, that sounds very great.
I searched the Mach3Mill users manual for the "Brain" and "Potkeys" how you called it. But I didn't find any descriptions.
Maybe you can help me?

Tine

2
General Mach Discussion / Re: need help with input signals!
« on: August 24, 2009, 05:01:43 AM »
i have got step motors with 0,05° per mm.
do you need special or more exact informations?
The force Sensor gives out voltage signals of 0-2V depending on the force.

3
General Mach Discussion / need help with input signals!
« on: August 24, 2009, 02:42:29 AM »
Hello,
I haven't got much knowledge in Mach3Mill.
So I hope you can help me to solve my problem:
I want to regulate the speed and the direction of the motors with one input signal each.
The input signal is given by a force sensor in voltage.
Is this possible?
Can you say me how I have to configurate Mach3 Mill?
Thanks!

Kind regards, Tine

Pages: 1