Messages

51

General Mach Discussion / Re: Alarm Driver Watchdog Triggered

« on: November 03, 2009, 01:07:29 AM »

thanks Hood, i disable this alarm and until now all well.

greeting

52

General Mach Discussion / Alarm Driver Watchdog Triggered

« on: October 31, 2009, 12:31:32 PM »

Hi good day, i was working yesterday with my mill and and this stop and the alarm that appeared no was STOP External, was Driver Watchdog Triggered. this was a own error inside the mach3. why? My computer is a Pentium3 512Mb Ram.

In other Milll happened that press the key Space (FeedHold) the machin stop very strong without aceleration, this happened several times. This PC is a CorelDuo 2GRam.
This happened only one day and no was due a driver.

Some explication a this.

very thanks
Renato

53

General Mach Discussion / Re: mouse interrupt the math3

« on: August 19, 2009, 01:01:01 AM »

thanks, i can now move the mouse and change the screen for example a MDI while run program. The driver no generate alarm, i continue the following steps.

* Continue some configuration of the Windowns XP Optimization.
* reduced Step Per a half.
* reduced the frecuency a 45khz.
* reduced aceleration of 200 a 150 mm/s^2

i will continue tested.

regards.

54

General Mach Discussion / Re: mouse interrupt the math3

« on: August 16, 2009, 10:54:26 PM »

thanks i download recomendation and will revise, some other suggestion,,

very thanks.

55

General Mach Discussion / mouse interrupt the math3

« on: August 16, 2009, 03:27:07 PM »

hi forum, i am concerned that when you move the mouse when the match3 it is running at high speeds, the driver generates an alarm for high acceleration.

This only happens sometimes but i'm concerned because the mouse stops the frequency of output pulses for a few moments.

The alarm of  high accelerations also occurs when change the MDI window while running the program. Also when i installed NOD32.

My parameters are:

step per:    787.4015
velocity max:  2000mm/min
aceleration:  200mm/s^2
Width pulse:  5us
PC:  Pentium 4, 512M, 1.6Ghz

what steps can i take? help

regards

56

Mach4 General Discussion / Re: New people welcome !! Come in here and introduce your self!

« on: August 16, 2009, 03:10:21 PM »

hi all, my name is Renato Masias from Lima, i am happy and desirous of learn more, i make retrofits and small machin cnc with math3

regards.