Messages

31

General Mach Discussion / Re: input read frequency?

« on: May 07, 2010, 01:50:07 PM »

hi, the signs of input for Home also is read each 100ms?. Then would have a error in zero machine, this is correct?
I think which the measurement should be done in less time, minor a 10ms.

regards

32

General Mach Discussion / Re: Random Estops occuring

« on: April 14, 2010, 02:38:36 AM »

work your logic PLC with 24v is more sure and robust against noise

regards

33

General Mach Discussion / Re: Program locking up before finishing.

« on: April 13, 2010, 12:37:24 AM »

It is an internal alarm in the match, prove disable the antivirus, also Use WatchDog disable en General Config.

regards

34

General Mach Discussion / Re: Mach3 by Linux

« on: April 13, 2010, 12:35:54 AM »

sorry i mistook the topic 

35

General Mach Discussion / Re: Mach3 by Linux

« on: April 13, 2010, 12:33:23 AM »

It is an internal alarm in the match, prove disable the antivirus, also Use WatchDog disable en General Config.

regards

36

General Mach Discussion / Re: So what IS "driver watchdog triggered"???

« on: April 11, 2010, 02:52:23 PM »

In my case when had active the Use Watch dog this stop my mill, the alarm came internally of the PC, then disconnected this and no had more problem.

BUT a few days ago find a Use Watch dog active without reason some, neither i nor my partner activate it, then turn it off immediately to avoid internal stops.

How can be this possible? what happens to match?

regards

37

General Mach Discussion / Re: mach 3 driver test program

« on: April 11, 2010, 02:30:21 PM »

Other problem when the pc turn off is send pulse that can ignite the M3 and M4 at the same time, and trigger a stroke on the motor or burning fuses.

Normally closed contactors cancel the M3 and M4 are not fast enough to protect the shooting of PC.

regards

38

Show"N"Tell ( Your Machines) / Re: Success! Mini Machining Center under Mach3 control - Video link

« on: April 09, 2010, 10:49:15 PM »

Is correct, output diferential in step/dir signal is more resistant to the noise that step/dir a ground.

I did the test putting the signal step/dir single ended hit to the motor and it lost many pulses, 
but the differential sign didn't lose none pulse.

regards

39

General Mach Discussion / Re: "Press Cyclestart After Tool Change", can it be disabled?

« on: March 23, 2010, 02:00:19 AM »

hi, you have to go a Config after choice General Config, in the side right is three option for the Tool Change, choice the first that is Ignore Tool Change and save the changes.

regards.

40

General Mach Discussion / Re: can mach record every move

« on: March 10, 2010, 08:14:10 PM »

In match3 mill this have a wizard for save all movement, i used this no memory which, i suppose which match lathe also have this wizards.

regards.