31
General Mach Discussion / cutting circles
« on: January 09, 2011, 06:46:58 PM »
i have been cutting some 1.5 inch circles in 1/2 ply using a .375 bit
the problem i am having is that the circle in not coming out completly round.
the problem seem to happen where the bit enter the material.
there is a small teardrop in that area.
its in that area where the circle is not completly round.
can anyone help
paul
the problem i am having is that the circle in not coming out completly round.
the problem seem to happen where the bit enter the material.
there is a small teardrop in that area.
its in that area where the circle is not completly round.
can anyone help
paul