Topics

31

General Mach Discussion / Mach3 fie problems

« on: October 10, 2009, 12:20:08 PM »

>
> I am new to mach3. downloaded the trial program trying to run a few files
that i made using vcarvepro i made a few squares run them and everything seem
to go ok
> i then made a file with a circle and also some with diff shapes.
> those dont run.
> when i import these files into mach3 the files is highlighted about the center
on the list of code.
> hit cycle start nothing moves.
> any help?
> paul

the file i am using is of a 18 inch circle with 23 lines of code
when i load the file the 8 line is highlighted when i use the rewind
button and go to the top [start of code] file would run until it reach the eight
line and stop.
looking at the table display mode this show a straight line been drawn no part
of a circle.
I have tried a number of circles and they are all the same.
but never a problem with squares i made a file with 20 squares and that worked.
i made a file with a circle and a square together that dont work.
thanks paul

32

General Mach Discussion / Mach3 screen

« on: October 04, 2009, 10:53:47 AM »

I am having problems with my Mach3 screen     its to big on the monitor screen. all the other programes
that i run everything works correct.
tried adjustment to the screen but nothing works.
i am using a dell 17inch flat screen.
the computer is an older pentium 3.
thanks for any help
paul

33

General Mach Discussion / Mach Manual

« on: August 16, 2009, 09:07:44 AM »

does anyone know if i can purchase the Mach Manual online?
and is there a link to that page.
thanks paul

34

General Mach Discussion / Tutorials Videos

« on: August 15, 2009, 02:03:35 PM »

Can anyone tell me if the tutorial videos are working  been trying and no luck getting them to work
thanks paul