21
General Mach Discussion / Diameter changes .001 every part.
« on: December 06, 2018, 09:39:59 PM »
Just finished converting a lathe. Gecko's, Nema 34's. Mach3 Lathe.
I turn a diameter and dial in to the correct size and the next part is perfect. THEN! the next part is .001 larger than the first. Hit cycle start again and the third part is .001 larger than the second. Now I know your thinking i'm loosing steps but I have the rapid speed way down and acceleration ramp looks like a triangle. Z axis is a 1200 Oz and X axis is a 600 Oz motor with a 2:1 belt drive. Way more motor than I need. The weird thing is the error is exactly the same every time. Is there a setting in Mach Lathe that could cause something like this to happen? Could the Gecko be configured wrong? Anybody ever heard of something like this happening?
I turn a diameter and dial in to the correct size and the next part is perfect. THEN! the next part is .001 larger than the first. Hit cycle start again and the third part is .001 larger than the second. Now I know your thinking i'm loosing steps but I have the rapid speed way down and acceleration ramp looks like a triangle. Z axis is a 1200 Oz and X axis is a 600 Oz motor with a 2:1 belt drive. Way more motor than I need. The weird thing is the error is exactly the same every time. Is there a setting in Mach Lathe that could cause something like this to happen? Could the Gecko be configured wrong? Anybody ever heard of something like this happening?