Hello Guest it is March 28, 2024, 11:23:29 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - jafc76

Pages: 1
1
Show"N"Tell ( Your Machines) / Spindle water cooling system 2.2KW
« on: December 30, 2011, 08:26:33 AM »
I wanna show my solution for the water spindle, it's working so good.

http://youtu.be/Qy_ja34B8ng

At 35 degrees the fans and LED's switch on, at 33.9 off.

I couldn't find so many information about this so I wanna share my solution.

Juan

2
General Mach Discussion / Mach3 on Windows 8 working well
« on: November 29, 2011, 11:01:47 PM »
Yesterday I installed Windows 8 Developer to have a look to this OS. I installed Mach3 on it and seems to work well.
In a few months Microsoft will release the final version so if Mach3 is working, I think is a good new.

Juan

3
General Mach Discussion / Why Reset two times?
« on: June 24, 2011, 05:30:59 AM »
It's not a big problem, but I don't understand why I have to press Reset button two times to reset the limit switches of my new CNC router.

Any idea?

Thanks in advance

4
SmoothStepper USB / Outputs problem
« on: June 22, 2011, 07:52:48 AM »
Hello, I bought a C10 BOB and a C36 relay board from CNC4PC that I'm using on Port 2 of the Smoothstepper, on Port 1 I'm using a DMM-Tech BOB because I'm using servos for my new CNC router.

I'm using a Smoothstepper because I use a laptop with Mach3 so I don't have LPT port.

My problem is that when Mach3 is running, the outputs are working fine, but when I shut down Mach3, the BOB's energizes the outputs. As soon as I boot Mach3 again, it shut the outputs off again and are working fine.

What's the problem?

It's very dangerous because the outputs are working always when I switch on the power supplies for the electronics, then with Mach3 working, the outputs are working well and I can switch on and off without problem, but when I shut down Mach3, the outputs are on again.

These are the BOB's:

http://cnc4pc.com/Tech_Docs/C10R10_USER_MANUAL_V2.pdf

http://www.dmm-tech.com/Files/Mach3Configuration_v01.022.pdf

Thanks

Juan

Pages: 1