Hello Guest it is April 16, 2024, 08:57:48 AM
Profile Guest

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - birlan

Pages: 1
1
General Mach Discussion / Re: mach3 motor configuration
« on: July 30, 2009, 03:04:36 PM »
After fresh reinstall with (Standard PC) option  - everithing is working now !
Thank you all !

2
General Mach Discussion / Re: mach3 motor configuration
« on: July 30, 2009, 08:01:58 AM »
Quote from: Hood on July 30, 2009, 07:49:08 AM
Please attach your xml.
Hood

I reinstal the sistem now and choose the Standard PC - I dont have any file left on it !
But What xml do you need ?


3
General Mach Discussion / Re: mach3 motor configuration
« on: July 30, 2009, 07:15:19 AM »
I don't have any printer install or any other drivers except via4in1.
It's xp+sp3 + updates - fresh installed last night. After reboot it work fine for about 8-10 seconds, and then loose step, anoying comportament of the motor (when I move the mouse, the motors take speed).
should I uninstall sp3 ?
I don't find in bios any ACPI (enable/disable), I have disabled Com ports, Paralel port change to ECP, load fail safe bios defaults, without any luck !
What drivers should I uninstall ?


4
General Mach Discussion / Re: mach3 motor configuration
« on: July 30, 2009, 03:04:40 AM »
It work fine , but I have to move the mouse. When the mouse is still (mouse pointer don't move on the scree, I don't touch the mouse , the motor not working well - lot of vibration, low speed loose steps etc...). All I have to do is movind the mouse and work fine .

Could anyone help me ?

PS: I have AMD 2800+ 1GB RAM, Optical mouse , winxp (updated) - fresh install.

5
General Mach Discussion / Re: mach3 motor configuration
« on: July 29, 2009, 07:56:50 PM »
The drivers are made with A3977 and they have 2 jumpers for step configuration , full step, half step, quarter step and eigth step

6
General Mach Discussion / Re: mach3 motor configuration
« on: July 29, 2009, 07:39:36 PM »
Hi,

Pitch screw = 2mm
Bipolar 200 step motor
Gear ratio = 2:1 (screw gear : motor gear)
Metric

7
General Mach Discussion / mach3 motor configuration
« on: July 29, 2009, 06:02:18 PM »
Hello,

I have 200 step motor and I cannot setup motor turning smoothly.
Could anyone can help me to fill boxes from "Motor turning and setup" window !

Any help will be appreciated !

Birlan

Pages: 1