211
General Mach Discussion / Re: Mach 3 Crashing PC
« on: July 21, 2009, 11:13:07 PM »
My machine has been working fine for quite some time, but I had not used it in a couple months. I started it up a few days ago to make some replacement parts, and whenever I start Mach 3 the computer reboots.
I have:
Virus scanned
Memory tested
Drive surface scanned
Re-installed a clean copy of Windows
Installed the newest version of Mach 3
I can start Mach 3 with any profile file, and it still causes the machine to reboot within a minute even if the program is just idling.
Also, I was wondering if there was some particular LPT configuration I should use?
Anyway... it was working, and now its not.
I have:
Virus scanned
Memory tested
Drive surface scanned
Re-installed a clean copy of Windows
Installed the newest version of Mach 3
I can start Mach 3 with any profile file, and it still causes the machine to reboot within a minute even if the program is just idling.
Also, I was wondering if there was some particular LPT configuration I should use?
Anyway... it was working, and now its not.