51
General Mach Discussion / Re: few problems
« on: January 10, 2010, 08:55:00 PM »
After homining etc I lode g-code, then start runing it as per config and m6start it goes to designated tool location I do tool change and touch off in same location.
Press start to continue, than machine goes first to machine coord 0,0,0 than work coord o,0,0 and then to tool path.
Why machine is going to machine coordinates 0,0,0 first? Is there setting in config?
Press start to continue, than machine goes first to machine coord 0,0,0 than work coord o,0,0 and then to tool path.
Why machine is going to machine coordinates 0,0,0 first? Is there setting in config?