Hello Guest it is March 29, 2024, 01:39:25 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - big-tex

Pages: « 1 2 3 4 5 6 7 »
11
There has been many discussions regarding parallel port cards and Mach3 port settings.
http://www.microcenter.com/product/417093/2-Port_Parallel_PCI_Host_Card

FYI This appears as same card as Roswell 304 just sold at brick and mortar store under diffrent brand.

12
your welcome

13
issue fixed check your email
if something needs further rework let me know

14
It should be cutting fine calculated offset will be positive #, if plate is below material it will be negative #.
If you refer to verions prior to 3.4 you need to do it using my site to get files.

15
Shot me emails I will resend install files, just in case of corruption

16
Keep in mind during install you need to indicate where mach3 is installed.

I do have youtube video showing installation process

https://www.youtube.com/watch?v=lVX537uj1cU&feature=youtu.be

Its is also good idea to have previous verion of my screen uninstalled as good measure.
Its been several years and I did not have all of my old filles to create installer as upgrade.


17
please let me know where is your mach 3 installed?

C://mach3

18
Finished Screens / Re: Mach Blue Probing by Big-Tex
« on: April 01, 2014, 03:49:53 PM »
go to youtube view videos and see how my modified screen works

http://www.youtube.com/channel/UC5Qyim0burbm82nptf1Rrsw

19
Officially out.

Thank you alll for great support

20
new version is released !

Pages: « 1 2 3 4 5 6 7 »