1
General Mach Discussion / Stepper Motors Overheating
« on: June 30, 2010, 02:48:37 PM »
Hi there!
I am using Mach3 to control 4 stepper motors. I am using appropriate power supply and drivers.
Everything is working good, except that motors are overheating when they are on but not in use (waiting for getting movement). Is there something that I should be to modify in Mach3 setup?
Any suggestion in this direction will be appreciated.
Thank You.
Eduardo.
I am using Mach3 to control 4 stepper motors. I am using appropriate power supply and drivers.
Everything is working good, except that motors are overheating when they are on but not in use (waiting for getting movement). Is there something that I should be to modify in Mach3 setup?
Any suggestion in this direction will be appreciated.
Thank You.
Eduardo.