This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Attachments - tjhj
Filename
|
Downloads
|
Message
|
Posted
|
pullymountt11.jpg |
938 |
Re: Advice on TTS Power Drawbar Design. |
March 30, 2010, 11:41:23 PM |
wormgearexpoldedview.jpg |
585 |
Advice on TTS Power Drawbar Design. |
March 30, 2010, 11:36:28 PM |
wormgearall.jpg |
563 |
Advice on TTS Power Drawbar Design. |
March 30, 2010, 11:36:28 PM |
simplethreadingscreen1_tjhjjpg.JPG |
535 |
Re: My Lathe has gone crazy, not on toolpath, Thread Cutting Issue |
November 20, 2009, 04:25:29 PM |
pullymountexploded11.jpg |
534 |
Re: Advice on TTS Power Drawbar Design. |
March 30, 2010, 11:41:23 PM |
pullymountlowerview11.jpg |
526 |
Re: Advice on TTS Power Drawbar Design. |
March 30, 2010, 11:41:23 PM |
wormgearview2.jpg |
505 |
Advice on TTS Power Drawbar Design. |
March 30, 2010, 11:36:28 PM |
Toolpost_tjhj.jpg |
478 |
Lathe Tool Compensation Is there a better way?? |
January 15, 2010, 04:55:43 PM |
simplethreadingscreen2_tjhj_jpg.JPG |
428 |
Re: My Lathe has gone crazy, not on toolpath, Thread Cutting Issue |
November 20, 2009, 04:25:29 PM |
MachineFiles_4_26_10.zip |
310 |
Mach Ignoring Tool Change Macro |
April 26, 2010, 10:19:54 PM |