This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Attachments - tjhj
Filename
|
Downloads
|
Message
|
Posted
|
Tjhj_X3_Mill.xml |
252 |
Spindle Control Takes 70% of processing power??? (Cant run spindle and G-Code.) |
May 05, 2010, 02:26:47 PM |
MachineFiles_4_26_10.zip |
310 |
Mach Ignoring Tool Change Macro |
April 26, 2010, 10:19:54 PM |
pullymountexploded11.jpg |
534 |
Re: Advice on TTS Power Drawbar Design. |
March 30, 2010, 11:41:23 PM |
pullymountt11.jpg |
938 |
Re: Advice on TTS Power Drawbar Design. |
March 30, 2010, 11:41:23 PM |
pullymountlowerview11.jpg |
524 |
Re: Advice on TTS Power Drawbar Design. |
March 30, 2010, 11:41:23 PM |
wormgearall.jpg |
562 |
Advice on TTS Power Drawbar Design. |
March 30, 2010, 11:36:28 PM |
wormgearexpoldedview.jpg |
584 |
Advice on TTS Power Drawbar Design. |
March 30, 2010, 11:36:28 PM |
wormgearview2.jpg |
504 |
Advice on TTS Power Drawbar Design. |
March 30, 2010, 11:36:28 PM |
Toolpost_tjhj.jpg |
477 |
Lathe Tool Compensation Is there a better way?? |
January 15, 2010, 04:55:43 PM |
LATHETtheadtxtfile.txt |
234 |
Re: My Lathe has gone crazy, not on toolpath, Thread Cutting Issue |
November 20, 2009, 04:25:29 PM |