31
General Mach Discussion / Re: Mach3 and stopping
« on: December 17, 2009, 11:13:22 AM »
what release of pokeys worked best for you?
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Homing sensor moved to back and oriented down to keep out as much swarf as possible.
I have my new Rutex servo drive and so far it is doing everything it claims to do, so I should get full speed and power from the motor. When I get it all back on the mill, I will make one final video and post the link. Questions, comments , criticisms or suggestions welcome.