21
General Mach Discussion / Re: New and confused
« on: May 17, 2010, 05:04:21 PM »
Hi
have been running mach 3 turn for 9 months with great success
have just finished converting an X3 mill and is now working ok
but am finding it a bit difficult compared with the lathe
I will only post one problem at time
1st one is I cannot get my programme to change tools
I am at the moment writing my own g code
I have set all my tool offsets into the table and am using G59 as my work offset 3 of the tools are in 7-8 and 9
when I call the tool in my programme by entering
G59 G43 H7
the dro with tool No doesn't change and the program uses the tool that was set up in the tool offset page
I must have done something wrong if anyone can help please
Colin
have been running mach 3 turn for 9 months with great success
have just finished converting an X3 mill and is now working ok
but am finding it a bit difficult compared with the lathe
I will only post one problem at time
1st one is I cannot get my programme to change tools
I am at the moment writing my own g code
I have set all my tool offsets into the table and am using G59 as my work offset 3 of the tools are in 7-8 and 9
when I call the tool in my programme by entering
G59 G43 H7
the dro with tool No doesn't change and the program uses the tool that was set up in the tool offset page
I must have done something wrong if anyone can help please
Colin