1
General Mach Discussion / steppers loose steps
« on: July 07, 2009, 05:10:32 PM »
I have a taig with steppers and a geco board but my x axis looses steps sometimes not responding at all. I switched axis plugs and the problem moves to the Y axis
sometimes it is better with faster feeds (above 1.0)
the only thing I see is it has a message bwm bumped to min setting anyone know what this means?
thanks
sometimes it is better with faster feeds (above 1.0)
the only thing I see is it has a message bwm bumped to min setting anyone know what this means?
thanks