21
General Mach Discussion / Stepper motor Speed.
« on: June 22, 2009, 10:54:55 PM »
Hi there,
I have just finished my CNC router and wired up the electronics, keling steppers ,controller and C10 breakout board. steppers will move with keys and typed code OK. but I can't get any speed out of them. I have at the moment motor tune set at 200 and 1 microstep. I can't see what I am missing to make the steppers run properly.
Thanks
best regards
Bernie Byers
I have just finished my CNC router and wired up the electronics, keling steppers ,controller and C10 breakout board. steppers will move with keys and typed code OK. but I can't get any speed out of them. I have at the moment motor tune set at 200 and 1 microstep. I can't see what I am missing to make the steppers run properly.
Thanks
best regards
Bernie Byers