Messages

101

Newfangled Solutions Mach3 Wizards / Re: "Cut Keyway" Issues (2.82)

« on: August 17, 2009, 09:29:04 AM »

Another issue with the cut keyway - when I set the step to 1mm and the ramp to 0 the output will only increment in 0.0785mm steps and it still ramps across the whole cut. I tried a 16 mm cutter start xy0 and end x0y6 with a 6.5mm depth in 1mm increments.

102

FAQs / Re: A Axis Setup as Degrees

« on: June 18, 2009, 02:50:00 AM »

Thank you for the help, at this time I believe that I have done all the above. I will check this on the weekend, as If I have then there may be a problem with my step controller or calculations.

103

FAQs / Re: A Axis Setup as Degrees

« on: June 17, 2009, 04:09:12 AM »

Yes I have done this in a test, however this does not change anything in terms of readout or doing the motor set-up. All the readings and terms still relate to distance as opposed to Degree's

104

FAQs / A Axis Setup as Degrees

« on: June 16, 2009, 09:57:36 PM »

Could any one provide details as to how to set the A Axis to read or relate to degrees. I am setting it up to an indexing head and the reading is in MM's and I would like to set it up to Degrees. I haven't set the drive config up yet as I am unsure of how to do it. I have been through all the documentation I can find and am a little bamboozled.