1
General Mach Discussion / Re: Tormach OEM version
« on: June 23, 2009, 11:30:09 AM »Randy,
I'm fighting a 0.004 backlash on the Y axis right now. I'm about to replace the shaft mount bearings, with fingers crossed.
BH
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Hi,
As I understand it, the issue of voiding the warranty is that the Tormach OEM version has been fully tested and has been configured to suit the machine.
If you use the latest development version of Mach and have a runaway situation that damages the machine, Tormach do not want to be responsible for any damage caused to the machine.
Seems fair enough to me.
Cheers,
Peter.
Thanks.
I would hope that changing software would not invalidate the warranty on the mechanics, but in any case, I did not read that in the docs, and I won't go looking.
BH