Messages

61

PoKeys / Re: Pokeys with Mach Turn

« on: February 12, 2010, 09:13:15 AM »

Also I'm now getting the message "No Pokeys device found"

62

PoKeys / Re: Pokeys with Mach Turn

« on: February 12, 2010, 09:10:42 AM »

I wish it were that easy. Still nothing. I can't get the enable switch on the actual pendant to turn the LED on. Also how does mach know which button does what. Do I have to assign them pin numbers under ports and pins? Like I said the instructions pretty much suck on the website.

63

PoKeys / Re: Pokeys with Mach Turn

« on: February 12, 2010, 07:22:24 AM »

Ok I didn't have the plugin enabled under the config menu.

Now I'm having the issue of getting my MPG setup. Im using the 4axis mpg from CNC4PC.com. There instructions are very brief.

Any help is appreciated.

64

PoKeys / Re: Pokeys with Mach Turn

« on: February 12, 2010, 06:39:24 AM »

I tried both still nothing. I tried installing the plug-in for multiple pokey's and then just a for the single one. I still can't see it under the plugin menu.

Any suggestions?

65

PoKeys / Pokeys with Mach Turn

« on: February 10, 2010, 07:56:36 AM »

Hello, I have the pokeys plugin and software installed on my computer and I'm looking to use it with Mach Turn.

When I open turn, there is no plugin under the drop down menu for pokeys.

Now in the mach loader there is a profile for pokeys, but it comes up for the mill control.

Are these not compatible?

Thanks, Scott

66

General Mach Discussion / Re: Master Cam9 Issue

« on: October 16, 2009, 01:17:00 PM »

Fixed thanks a million

-Scott

67

General Mach Discussion / Master Cam9 Issue

« on: October 16, 2009, 11:03:50 AM »

I loaded the MasterCam9 Post processor off the mach3 page and installed it. When i post the code I get the first picture. It is suppse to look something like the 2nd picture. Any Ideas?

68

General Mach Discussion / Re: Touching Tools

« on: August 26, 2009, 09:56:32 AM »

Nobody Knows?

69

General Mach Discussion / Touching Tools

« on: August 25, 2009, 11:44:57 AM »

I'm having a hard time grasping the tool length offset (G43) But my question is this. Can't you just touch each tool off a gage block of say, 2" and then hit the "Set tool offset" button? Then once the tool is called in the program Mach willl adjust for the given height. Is this how it works?

70

PoKeys / Re: Momentary switches

« on: July 22, 2009, 03:58:28 PM »

Thanks for the reply