Messages

1

Mach Screens / Font Size of Gcode window

« on: June 29, 2012, 06:55:11 PM »

The lines of my Gcode windows are too big, so they overlap.

How can I change the size?

My screen is set to 1024x768

I have tried in all setups and the same. I have tried with Screen4 but I can't find what to change.

Any help appreciate.

2

FAQs / Re: Jogging problem Z+ and Z- always goes UP

« on: April 03, 2012, 03:58:05 PM »

Z dir is ok. I tried reinstalling Mach3 and it worked fine.

Thanks anyway.

3

FAQs / Jogging problem Z+ and Z- always goes UP

« on: April 02, 2012, 04:09:06 PM »

I had to make a fresh installing of MACH3. But with jogging axis Z keys UP and DOWN make Z go up.

hotkeys for Z are 33 and 34

Any help appreciated

Rick

4

General Mach Discussion / Re: Plasma Application, Mach3 torch height control.

« on: January 15, 2010, 07:44:15 PM »

Greetings for all:

I am little lost about how to set up THC feature of Mach3. Do I need some external divice to control the torch? or is just an option? if not, how do I configure the thc in Mach3 to work?

Is there any schematics? I have looked all over for info. like this. The Mach3 docs are very poor and dont tell how to use THC in it.

Any help appreciated.

Richy
 

5

General Mach Discussion / THC setup for Mach3

« on: January 14, 2010, 06:38:28 PM »

Hi everyone,

I have a plasma cutting table. So far I use the plasma trigger manually, so I would like to Mach3 to control it. I would like some advices how to set up a THC feature.

Any help appreciated.

Richy