Hello Guest it is November 27, 2021, 09:17:34 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - sparky3

Pages: « 1 2 3 4
31
General Mach Discussion / Re: new computer
« on: January 16, 2006, 10:33:33 PM »
does on board video throw a problem into the works or just a bad image,  thats going to be harder

32
General Mach Discussion / new computer
« on: January 16, 2006, 09:53:03 PM »
hello all, i have just bought mach 3 and nfs wizzards.  now i am planning to build a dedicated computer for my machine.  do you have any sugestions for good platforms to look for or stay away from.  i am planning on a p4 processor 2.8 to 3.0 gh, 512 ram.  is there any thing else i should look for?
thanks

33
General Mach Discussion / mach 3 speed
« on: December 23, 2005, 07:44:48 PM »
hello all, i am looking at getting mach 3 and nfs wizzards from nfs just have some questions.  i wached the videos on mach support site and the from them i gather that you are safest working at 25000 hz , but are their any problems working at 35000hz. i am currently using flashcut and love the interface it operates motors at up to 35000hz, but i like the wizzards that you can use with mach.   i would also like to know about touchprobe applications can a macro be set up to touch off a part to find center of exiting hole, or side of a part?

Pages: « 1 2 3 4