1
General Mach Discussion / outputs
« on: February 15, 2013, 01:50:06 PM »
I have tried to get infomation on how to use the outputs in Mach. I read the manual, but it does not explain them other than spindle control.
What I would like to do is use output 2 (pin 14) to turn on and off a laser crosshair, using the "L" button on the keyboard. I have a relay setup that will take care of everything after the BOB. Can someone please help with how to set that up.
Thanks in advance
Ray
What I would like to do is use output 2 (pin 14) to turn on and off a laser crosshair, using the "L" button on the keyboard. I have a relay setup that will take care of everything after the BOB. Can someone please help with how to set that up.
Thanks in advance
Ray