1
General Mach Discussion / Problem configuring ncpod
« on: May 14, 2009, 01:33:13 PM »
Hello all,
I have a problem to setup mach3 for ncpod.
The communication between Mach3 and ncpod is OK, but I don't manage to setup the soft to make move motors.
The following picture is my actual setup of mach 3, please tell me what is wrong.
Freddy
I have a problem to setup mach3 for ncpod.
The communication between Mach3 and ncpod is OK, but I don't manage to setup the soft to make move motors.
The following picture is my actual setup of mach 3, please tell me what is wrong.
Freddy