Hello Guest it is March 29, 2024, 04:06:14 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - rasta

Pages: 1
1
Hi , I wonder if someone has had the same problem than me today .
Loaded a simple Milling 2 1/2 D program that is using X , Y , And Z axis .The program works ok , until I pressed the feed hold button , the feed stops , and then when I press the cycle start again Mach3 select the 4 axis in place of the axis that was moving before I pressed the feed hold , this does not happen if instead of using the feed hold button I use the stop button.. Using Mach3 , with the ESS.. on win7
Regards
Mariano

2
Vistacnc Control Pendants / Shuttle RU
« on: February 05, 2020, 03:17:01 AM »
Hi;
I’m not sure that this is were I supposed to post this , but I will like some help
I have a shuttle RU , and the axis tends to run away if I use the jogging wheel , and it does until I press the stop button in the shuttle , or until I press the ESC in the keyboard.
Can someone please guide me on how to implement the ESC in one of the shuttle buttons? O I’m using the ESS , and Mach3
Thank you
Mariano

3
Bargain Basement / Kflop+ kanalog wanted
« on: July 23, 2018, 11:55:48 PM »
Hi;
Im After a Kflop+Kanalog boards, are there anyone that wants to sell?
regards
Mariano

4
Mach3 and G-Rex / MACH3 and Grex
« on: June 14, 2014, 04:05:11 AM »
Hi;
has anyone been successful in implementing backlash comp in the Grex?
also Mach3 and the G100 loses comm if a shuttle pro ring is used for jogging
many help please?

5
General Mach Discussion / Z probing not working on lset
« on: May 21, 2013, 06:08:53 AM »
Hi; im in the process of modifying my micro lathe to cnc, everything works ok , except the automatic tool probing,
it works perfectly in x direction , but it does not work in the z direction, the machine works perfectly manually or automatic
so i think that the tool probing macro is the culprit.
can someone please help?
thank you
Mariano
 ;)

6
General Mach Discussion / lathe tool changer
« on: April 19, 2013, 03:37:37 AM »
hi; im converting a micro lathe to cnc, and made a 8 position tool changer, that uses a taper dog clutch for positive location
before the controller energise the stepper to rotate to the next tool it must push the toolchanger head as per the "real "ones to clear the dog clutch slots
can someone please point me where I can download a macro that will be close to implement this figure?

thankyou
mariano

7
Feature Requests / Support for generic lathe posts
« on: January 29, 2013, 05:18:10 AM »
I would love to have G2 and G3  input  with just  R , and no need to I,K   In mach3  lathe


8
Mach3 and G-Rex / grex download manager not working
« on: October 31, 2009, 04:45:22 AM »

Hi;
after buying my grex more than a year ago , I desired to try to get it going
I have managed to set the address , and find the gecko , but the download manager
wont load , my browser (firefox) states that it is a network timeout.
can you help please?
thanks
mariano

Pages: 1