461
Show"N"Tell ( What you have made with your CNC machine.) / Re: Gertrude Gets Some!
« on: May 12, 2009, 03:04:09 AM »
ok heres that lathe issue. this time with pics!
see image with red line and arrows.. that part of lathe "wiggles" and tho i dont cut anything tougher than wax with this i still reckon i need to adjust something.. i think its loose on its guide. and the image after that shows the only adjustment i can see.. a series of little nuts n bolts...
im guessing i tighten those till wiggle goes away?
also while im on it.. i can pick up 4 axis kit with BOB , 1.8' steppers etc for 250USD.. now thats pretty croddy equipment im sure (right off ebay too) but would that be hard to rig that upto this lathe? is it worth doing this as a side project? (not that i need anymore side projects mind you)
see image with red line and arrows.. that part of lathe "wiggles" and tho i dont cut anything tougher than wax with this i still reckon i need to adjust something.. i think its loose on its guide. and the image after that shows the only adjustment i can see.. a series of little nuts n bolts...
im guessing i tighten those till wiggle goes away?
also while im on it.. i can pick up 4 axis kit with BOB , 1.8' steppers etc for 250USD.. now thats pretty croddy equipment im sure (right off ebay too) but would that be hard to rig that upto this lathe? is it worth doing this as a side project? (not that i need anymore side projects mind you)