Hello Guest it is March 28, 2024, 11:30:11 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Chris.Botha

Pages: « 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 »
271
some more stuff from this week.. one head.. then a remake after i read the packet properly.

and a 7 stone eternity ring, 3 sided

272
looks great!

273
got this baby on today. Clockwork. nice to have a dependable mill...



274
i would attepmt to touch probe and/or laser scan and mill purely for the technical hell of it. vulcanizing it would just be plain out right naughty ;)

275
i have nothing that can scan that fine. been playing with david laser scanner but thats not really much good at anything smaller than 6 inches or so.




277
nope. same issue persists.

want me to upload some code tonight?



278
K Will download and test later today.

279
this one :)


280
not a complaint. merely an observation.

my screen gives me a program run extreme synopsis as i load my gcode which lets me know how far either side of XYZA 0 my part will move,  great feature as i can quickly check what size wax to chop up for a job, but if i path with ARCS then these extremes can reach bizarre false limits and has made it impossible for me to setup softlimits since they are almost always overshot by this error.

as an example a small ring with x not going more than say  20mm either side of X0 may be read be program extremes as being from -X780 thru +X1980 if i path the flip cuts with arc outputs into the code. 

perhaps this is a known issue and someone has allready solved it?


Pages: « 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 »