221
SmoothStepper USB / Re: Does it reduce CPU load ?
« on: August 14, 2009, 04:36:12 PM »
Ken.. i suppose it might be asking a bit much but the ultimate test would be to hook your mill up to the parallel port, load a big path and cut air.. monitor processor usage then do the same while running it through the SS.
Not that i would ask you to do such a thing of course....
Did you require a cable conversion as mentioned above?
At 155 dollars i suppose im not loosing much giving it a shot... but im not keen to start editting my code because of the issues you getting
thanks for feedback.
Regards
Chris
Not that i would ask you to do such a thing of course....
Did you require a cable conversion as mentioned above?
At 155 dollars i suppose im not loosing much giving it a shot... but im not keen to start editting my code because of the issues you getting
thanks for feedback.
Regards
Chris