141
General Mach Discussion / Re: Help needed
« on: December 18, 2010, 07:21:09 PM »
Man this is so much fun....
I did not change anything....
Anyway - I do not know if it is my Y or X axis because I did not mark the material. I cut a 2"x2" square and it ended up being 2" exactly on one side and 1.98" on the other side.
That is pretty close.
Is it worth trying any further or do you think that is close as it gets?
Thanks -
Keith
I did not change anything....
Anyway - I do not know if it is my Y or X axis because I did not mark the material. I cut a 2"x2" square and it ended up being 2" exactly on one side and 1.98" on the other side.
That is pretty close.
Is it worth trying any further or do you think that is close as it gets?
Thanks -
Keith