1
General Mach Discussion / Re: Z axis 0
« on: May 04, 2009, 09:01:40 PM »
I re-installed Mach3 over the previous installation. There is no change.
I might uninstall and try a fresh install.
I also removed Shuttlepro and jogged with the keyboard, but it made no difference with the Zero problem.
Any other thoughts?
Thanks.
Jim
I might uninstall and try a fresh install.
I also removed Shuttlepro and jogged with the keyboard, but it made no difference with the Zero problem.
Any other thoughts?
Thanks.
Jim