Messages

11

General Mach Discussion / Re: step error

« on: April 16, 2009, 05:25:03 AM »

i already did but the program give an error on of your motor axises is tunned to fast for the kernel speed so i increase kernel gradualy but i still have the same problem by the end i made kernel speed 1mhz i have all other xml files for yesterday i'll attach it

12

General Mach Discussion / Re: block some parameter

« on: April 16, 2009, 05:11:00 AM »

i'm sorry but i mean after i setting my mach mill and for example calibrate the motor and sell it i'm in need to prevent user to change calibration and my be other parameter can i do this in mach 3

13

General Mach Discussion / Re: step error

« on: April 16, 2009, 05:05:48 AM »

dear hood this is the last xml ido yasterday

14

General Mach Discussion / Re: step error

« on: April 15, 2009, 05:38:07 PM »

this xml
F1000 (i.e. faster than possible but Mach3 will limit speed)
G20 G90 (Inch and Absolute)
M98 P1234 L10 (run subroutine 50 times)
M30 (stop)
O1234
G4 P02
G1 Y40
G4 P02
G1 X40
G4 P02
G1 Y-40
G4 P02
G1 X0 (do a feed rate move and move back)
M99 (return)
%

15

General Mach Discussion / Re: step error

« on: April 15, 2009, 04:24:41 PM »

dear friends
i start today to test the machine but i'm very surpriues because when i change the feed rate i found the distance also change acoording to feed rate vatue can anyone help me
thanks

16

Finished Screens / Re: iMach3 Screen

« on: April 14, 2009, 12:02:21 AM »

hanks i'll go to this website

17

General Mach Discussion / Re: step error

« on: April 13, 2009, 02:43:52 PM »

i already increased the puls width to 5 for pulse width but not for direction puls
now i choose active low i'll try to use active high then i'll inform you

18

General Mach Discussion / Re: output puls wave form

« on: April 13, 2009, 12:24:18 PM »

by another way if i increase feed rate what will hapen in the output pin then the effect of motor

19

General Mach Discussion / Re: output puls wave form

« on: April 13, 2009, 10:42:16 AM »

i mean that what's the relation between output puls and feed rate in mach3

20

General Mach Discussion / Re: changing between mm and inch

« on: April 13, 2009, 10:40:10 AM »

ok thanks